Redesign Paving

Redesign Paving Spezifikationen

Anwendungsbereich:

Redesign Pflaster wird auf allen Gebieten, die mehr als 6 lineare Füße von Rissen in jedem 4 Quadratmeter Fläche enthalten, durchgeführt werden. Bestehende Asphaltdecke muss ohne Überhitzung zu Hot-in-Place-Recycling von 2 cm in der Tiefe ermöglichen erhitzt werden.

Materials:

1- Rejuvenating oil. Rejuvenating will have the following properties:
a. To help control rutting rejuvenating agent will have a Viscosity of 20 centistokes or greater at 40 Degree Celsius.
b. To help control thermal cracking rejuvenating agent will have a Pour point of -20 Degrees Celsius or below.
2- Makeup asphalt. New hot mix asphalt or RAP with an oil content percentage of 4% or greater shall be added as necessary to bring compacted patch to level of the existing roadway.
3- Sealcoat. Sealcoat shall be Diamond Roads Gilsonite sealer or approved equivalent.

Equipment:

Equipment used for asphalt recycling shall conform to the following specifications:
1- Smoke leaving the recycler shall have an opacity of 20% or below at any location at all times. Smoke intermittently exceeding 20% opacity shall not be allowed.
2- Heating of the pavement shall be controlled so the pavement temperature does not ever exceed 200 Degrees Celsius.
3- To protect overhead trees and for personnel safety, hot gases leaving the recycler shall not be hotter than 100 Degrees Celsius.
4- Equipment shall include but not be limited to shovels, rakes, lutes, hand torches, hot boxes containing RAP or virgin asphalt, in-place-heaters with and without screeds, brooms, hand and vibratory reversible plate compactors, sealcoat sprayer, rejuvenator heater and sprayer, mechanical brooms, hand laydown boxes, ten foot level, asphalt fines separator, and other necessary equipment to recycle asphalt.

Procedure:

1- Pavement to be recycled shall be heated three inches wider in all directions of the area to be patched to provide a hot bonded joint.
2- Joint between newly recycled asphalt and existing roadway surface shall be angled at an angle of 45 degrees. This will reduce or eliminate water penetration into the joint and eliminate low compaction areas in the joint.
3- The asphalt pavement surface shall be heated for a minimum of 6 minutes. If the contractor is unable to recycle to a depth of two inches and can demonstrate that the pavement has been heated for 10 minutes with the surface temperature remaining between 150 to 200 degrees Celsius, a recycle depth of 1.5 inches will be acceptable and receive full pay.
4- Rejuvenating oil shall be added at a rate of ¼ percent to ¾ percent oil by weight of the recycled asphalt. Total oil content plus rejuvenating oil shall not produce a recycled asphalt pavement with a void content of less than 3% at 100 % compaction.

Pay item:

1- Mobilization
2- Per patch each.
3- Per square foot.
Pay shall include all equipment and materials to accomplish asphalt recycling as per the specifications.